TFK Joggster velo, Operating Manual

Page: 10 / 16

10
OPERATING AND ASSEMBLING MANUAL
(Fig.I) Unfold the JOGGSTER velo by pulling the handle (1) upwards until the
folding hinges (2) have safely clicked into place. Before use , please make
sure that the folding hinges are safely clicked into place.
(Fig.II) The seat is attached to both sides of the frame with four push buttons
(a) per side and then with three more push buttons (b) in the footroom.
(Fig.III) Additionally, attach the seat with the help of the two straps on the
bottom of the seat bench (d) . Furthermore, connect with 2 push buttons (c)
each, left and right between the seat and the basket. Then close the hook-
and-loop fasteners
(e) to ensure the weather protection.
(Fig.IV) Finally, close the four belt fasteners (3) on the back of the backrest.
To do this, you need to insert the locks on the seat cover far enough into the
connecting piece that you hear them click into place.
(Fig.V) Insert the hood on the left and right in the designated holding fixtures
(4) . The hood doubles as a rollover protection and, therefore, must be
attached with a screw. Then, secure it at the height adjustment with the
hook-and-loop fastener
(5) by guiding the band through the slit in the cover
and around the bar, Then pull it through the strap and close the hook-and-
loop fastener. To open the hood, fold hood forward until it audibly clicks into
place. The front hood frame is a rollover protection. The hood must always
be open when used for sports or as a bike trailer. If you would like to fold it
up, press the two push buttons on the holding fixtures
(4) .
(Fig.VI) To connect the hood to the seat, attach the two push buttons (6) on
the back of the seat cover at the top, as well as the hook-and-loop fasteners
on the left and right between the hood and the seat cover
(7) .
(Fig.VII) Inside the hood you can find an integrated sun and insect
protection screen (8) . Remove the screen from the pouch and stretch it
around the bottom frame bar. In addition, attach the screen on the left and
right on the hood holding fixture
(4) by hanging the elastic bands around the
designated hooks.
ATTENTION : If you are using the JOGGSTER velo as a bike trailer, you must
absolutely use this security measure.
(Fig.VIII) In the rear hood pouch (9) you can find the integrated weather
protection (10) . Open the bottom zipper, take out the weather protection,
pull it forward and stretch it over the front frame bar. Additionally, press
together the two push buttons
(11) on the back of the backrest and close
the latches (12) around the frame on the left and right at the height
adjustment.
(Fig.IX) To fold up the JOGGSTER velo, stand behind the buggy and unlock
the folding joints (2) . To do this, pull the grey levers (13) towards you with your
index fingers and push the push bar forward (1) .