25
24
METEO SENS
- Wireless weather station
METEO SENS
- Wireless weather station
• The LED signal lamp flashes.
• Open the battery compartment of the base station and insert two new AA 1.5V batteries, polarity as
illustrated.
• All segments will be displayed briefly.
• Close the battery compartment again.
6.2 Reception of the transmitter
• After the batteries are inserted the base station will automatically receive the measured values. The
reception waves beside the channel number 1 flash. If the reception of the measured values fails,
”--” appears on the display. Check the batteries and try it again. Check if there is any source of inter-
ference.
• As soon as the base station receives the radio-controlled time, you can start the manual initialization
of the transmitter. Press and hold the
CHANNEL
button for three seconds. The base station will try to
receive the measured values.
• Press the
TX
button on the transmitter to transmit the measured values manually.
6.3 Radio-controlled time reception
• After the base station has completed the search for the transmitter, the device starts scanning the
DCF signal (radio signal) and the DCF reception symbol flashes.
• When the time code is successfully received after 2-12 minutes, the radio-controlled time, the date
and the DCF symbol will be shown steadily on the display.
• You can also start the initialization manually.
• Press and hold the
RCC/-
button for 3 seconds.
• The DCF reception symbol will be flashing.
• Interrupt the reception by pressing the
RCC/-
button again.
Buttons (Fig. 1)
B 1:
SET
button
B 2:
CHANNEL
button
B 3:
button
B 4:
RCC/-
button
Housing (Fig. 2)
C 1:
Battery compartment
C 2:
Stand
Transmitter (Fig. 3)
D 1:
Channel search switch
D 2:
TX
button
D 3:
LED signal lamp
D 4:
Battery compartment
D 5:
Mounting hole
6. Getting started
6.1 Insert the batteries
• Place the instruments on a table at a distance of about 1.5 meters from each other. Avoid being close
to possible sources of interference such as electronic devices and radio equipment.
• Open the battery compartment of the transmitter.
• Set the switch to the channel 1 position.
• Insert two new AA 1,5 V batteries, polarity as illustrated.
• Close the battery compartment carefully.
TFA_No. 35.1139_Anleitung 11.04.2017 15:15 Uhr Seite 13
