23
22
Radio-controlled alarm clock
B: Buttons:
B 1:
Switch setting time and alarmtime, ALARM ON/OFF
B 2:
CLEAR button
B 3:
HR button
B 4:
5 and 15 and 30 button
B 5:
MIN button
B 6:
SNOOZE/LIGHT button
C: Housing:
C 1:
Battery compartment
6. Getting started
• Open the battery compartment and insert two new batteries 1.5 V AA, polarity as illustrated.
• Close the battery compartment again.
• The device will alert you with a beep and all segments will be displayed for a short moment.
• The indoor temperature (default °C) appears on the display. It may take 3-8 minutes until the correct temperature is dis-
played.
Radio-controlled alarm clock
6.1 Reception of the radio controlled time
•
Attention:
The radio reception only works in normal mode (switch to position AL ON / OFF)
• The clock will now scan the DCF frequency signal and the DCF symbol will be flashing on the display. When the time code is
received successfully after 7 minutes, the radio-controlled time and the DCF symbol are displayed steadily on the display.
• The DCF reception always takes place daily at 1:00, 2:00, 3:00, 4:00 and 5:00 o'clock in the morning. If the reception is
not successfully received until 5:00 o'clock, the next receive operation is again at 1:00 o'clock in the morning.
• You can start the initialization manually.
• Press and hold HR button for three seconds.
• The DCF reception symbol will be flashing.
• To end the DCF reception attempt, press the HR button short. The DCF reception symbol disappears.
• There are three different reception symbols:
flashing - reception is active
stays - reception is very good
no symbol - no reception/reception is shut down/set time manually
• If the clock can not detect the DCF-signal (for example due to disturbances, transmitting distance, etc.), the time can be
set manually. The clock will then work as a normal quartz clock. (see: Manual setting of the clock).
TFA_No. 60.2532_anl_08_21 29.08.2021 9:48 Uhr Seite 12
