– 26 –
– 27 –
SPOT –
Wireless Thermometer
• If the clock cannot detect the DCF-signal (e.g. due to interference, transmitting distance, etc.), the time can
be set manually.
• The clock will then work as a normal quartz clock (see: “Manual settings”).
Note on radio-controlled time
• The time is transmitted from an atomic clock near Frankfurt am Main by a DCF-77 (77.5 kHz) frequency sig-
nal with a range of about 1,500 km. Your radio-controlled clock receives the signal, converts it and always
shows the exact time. The adjustment of Daylight Saving Time and Standard Time is also automatic.
• During night-time, the atmospheric interference is usually less severe. A single daily reception is adequate to
keep the accuracy deviation under 1 second. In extreme cases, please place the unit close to a window to
improve reception.
7. Operation
7.1 Manual settings
• Press and hold the
SET/MAX/MIN
button for three seconds to enter the setting mode.
• The first adjustable value flashes on the display.
• Use the
+/CHANNEL
button to make the desired setting.
• Confirm with the
SET/MAX/MIN
button and go to the next setting.
• The sequence is shown as follows:
– DCF reception ON/OFF (default: DCF ON)
– Time zone -12/+12 (default: ZONE 00)
– Day-of-week language (default: GER)
– Automatic reset of the maximum and minimum values ON/OFF (default: MIN MAX AUTO OFF)
– Hours, minutes
– Year, month, day
• After all adjustments are completed, press the
SET/MAX/MIN
button to exit the setting mode.
• Press and hold the
+/CHANNEL
button in the respective setting mode for quick setting. The device will auto-
matically quit the setting mode if no button is pressed for 20 seconds.
SPOT –
Wireless Thermometer
7.1.1 DCF reception
• By default, the DCF reception is activated (DCF ON) and after successful reception of the DCF signal no
manual adjustment is necessary.
• Once the DCF reception is deactivated (DCF OFF) the time and date must be manually set. No time zone will
appear.
• If the DCF reception is activated, the manually set time will be overwritten by the DCF time when the signal
is received successfully.
7.1.2 Time zone setting
• In the setting mode you can make the time zone correction
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is
different from the DCF time (e.g. +1=one hour plus).
7.1.3 Day-of-week language setting
• In the setting mode choose the day-of-the-week language:
German (GER), French (FRE), Italian (ITA), Dutch (DUT), Spanish (SPA), Swedish (SWE), Czech (CZE) and
English (ENG).
7.1.4 Automatic reset of the maximum and minimum values
• In the setting mode you can activate or deactivate the automatic reset of the maximum and minimum values.
• By default, the automatic reset is disabled (MIN MAX AUTO OFF).
• If the automatic reset is activated (MIN MAX AUTO ON), AUTO appears on the display in normal mode.
• All maximum and minimum values will be reset automatically every midnight at 0:00.
7.2 Maximum/Minimum function
7.2.1 Indication of maximum and minimum values
• Press the
SET/MAX/MIN
button in normal mode to show the maximum (MAX) and minimum (MIN) values
of indoor and outdoor temperature since the last reset with time and date of recording.
TFA_No. 30.3030.01V2_Anleitung 24.08.2021 9:55 Uhr Seite 14
