Textron JACOBSEN GP400, Technical/Repair Manual

Page: 296 / 354

8-24 4252490-Rev A
CUTTING UNITS
8
Figure 8-19
Figure 8-20
3. Remove cotter pin (4) and flat washer (5) from
connecting pin (2).
4. Remove cotter pin (7) and flat washer (8) from
connecting pin (6).
5. Remove leveling rod assembly (3) from link arm (1)
and machine frame (9).
Installation Notes
• Apply marine lubrication grease to I.D. of rod
connecting pin (6) and reel leveling rod (3) at area
beneath the springs.
• Install reel leveling rod by reversing the order of
removal.
• Adjust leveling rod. (See “Cutting Unit Leveling
Adjustment” on page 8-21.)
Right and Left Lift Arms
Removal and Installation
See Figures 8-21 through 8-23.
NOTE
The left lift arm is shown; the right lift arm is similar.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Remove cutting unit. (See “Cutting Unit” on
page 8-22.)
Figure 8-21
3. Remove cotter pin (3) and flat washer (2), and
disconnect the leveling rod (4) from link arm (1).
Figure 8-22
TN3734
5
4
1
3
2
TN3735
9
3
7 8
6
TN3737
3
1
4
2
TN3738
8
12
10
11
13
9
5
6
7