SG4 Shotgun Shoe Group for 555
®
Series Electric Benders
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
6
Setup
Always use safety glasses. Everyday
glasses only have impact resistant
lenses; they are NOT safety glasses.
When using in dusty environment, use
face or dust mask.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Unplug the bender before changing accessories.
Accidental start-up could result in serious injury.
1. Slide the shotgun bending shoe onto the shaft of
the main sprocket, as shown. Align the four drive
studs on the back of the shoe with the four holes in
the main sprocket.
Installing a Shotgun Bending Shoe
2. Mount the support unit onto the bender. On 555CX
and 555DX benders, install the support unit onto the
eccentric shaft and pivot the support onto the leg
of the bender. Reinstall the hinge pin and locking
collar, as shown.
Note: If necessary, rotate the eccentric shaft until
the hinge pin lines up properly.
Install pin.
Roller Support Unit Installed on 555CX and 555DX
On the 555C bender, mount the support unit onto
the legs of the bender and install the hinge pin, as
shown.
Install pin.
Roller Support Unit Installed on 555C
3. Mark the conduit. Refer to the decals on the bender
or the “Additional Bending Instructions” section of
this manual.
4. Place the bender in either the vertical or horizontal
bending position.
