RK1550 15-ton, Single-acting, Die-type Crimping
Tool
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
6
Adapter Kits
(cont’d)
Procedure for Using Kearney PH2 Dies
48824 Die Holder Kit
1. Install 48823 PH2 die spacer assembly into hole
in top of “C” head. Snap in place with retaining
spring plunger (6).
2. Install upper 48825 die holder assembly into hole in
die spacer assembly. Lock in place with die spacer
retaining screw.
3. Install lower 48825 die holder assembly in hole in
end of piston. Snap in place with bottom die holder
retaining spring plungers (6).
4. Select proper die set for fitting to be crimped.
Note: Do not use non-butting dies (crimps con-
trolled by tonnage) in this tool, as damage could
occur to connectors and/or conductors.
5. Slide die into place in top die holder tight against
shoulder. Detent screw will snap into groove of
die. Lock in place with top die retaining cap screw.
Repeat operation for other die entry.
PH2 Die Holder Kit 48824 contains:
(1) 48823 and (2) 48825 Die Holders
TOP DIE HOLDER
RETAINING SPRING
PLUNGER (6)
48823 PH2
DIE SPACER
ASSEMBLY
DETENT SCREWS
TOP DIE
RETAINING
SCREW
48825 PH2
DIE HOLDER
ASSEMBLIES
BOTTOM DIE
RETAINING
SCREW
TOP DIE HOLDER
RETAINING SCREW
BOTTOM DIE
HOLDER
RETAINING SPRING
PLUNGERS (6)
