LP6 Hydraulic Crimping Tool
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
8
Hoses and Fittings
Installation and Maintenance
Refer to publication 99930323, SAE J1273
(Hose and Hose Assemblies).
Replacement
Refer to a Greenlee Utility catalog or publication
99910322, Low Pressure Quick Couplers, Adapters and
Hoses.
Do not disconnect tool, hoses, or fittings while the
power source is running or if the hydraulic fluid is
hot. Hot hydraulic fluid can cause serious burns.
Hose Connections
Tool Port Identification
Three methods are used to identify the pressure and
return ports of Greenlee Utility tools. Match the mark-
ings on your tool to this table.
Pressure Port
Return Port
P
T
or
In
Out
or
3/4–16 O-ring Boss
Connecting Hoses
1. Move the flow control lever on the hydraulic power
source to the OFF position.
2. Stop the hydraulic power source.
3. Connect the return hose to the return port on the
power source, and then to the return port on the
tool.
4. Connect the pressure hose to the pressure port on
the tool, and then to the pressure port on the power
source.
Disconnecting Hoses
1. Move the flow control lever on the hydraulic power
source to the OFF position.
2. Stop the hydraulic power source.
3. Disconnect the pressure hose from the power
source, and then from the tool.
4. Disconnect the return hose from the tool, and then
from the power source.
Typical Setup
