MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
28
Serial and Manufacturing Number Label
Part A of the Supplemental Information Label is located on the lower dash panel on the driver’s side. This label con-
tains the vehicle type if applicable, the Model, Date Code, Serial Number, Gross Vehicle Weight (GVW), Vehicle
Weight with Batteries and Nominal Horse Power.
Part B of the Supplemental Information Label is located just below Part A. This label contains the Rated Capacity
with Operator, Vehicle Weight Without Batteries, Maximum Battery Weight, System Voltage, Maximum Draw Bar
Weight and UL, FM or CE certification mark, if applicable.
Serial Number Bar Code Label
A smaller label containing the Serial Number and a Bar Code is located on the steering column.
REPAIR
Some servicing operations may require the front wheels,
the rear wheels, or the entire vehicle to be raised.
To reduce the possibility of severe injury or
death from a vehicle falling from a jack:
Be sure the vehicle is on a firm and level sur-
face.
Never get under a vehicle while it is supported
by a jack.
Use jack stands and test the stability of the vehi-
cle on the stands.
Always place chocks in front and behind the
wheels not being raised.
Use extreme care since the vehicle is extremely
unstable during the lifting process.
When lifting the vehicle, position the jacks and jack stands
at the areas indicated only.
Lifting The Vehicle
Tool List
Qty.
Floor Jack ....................................................................1
Jack Stands .................................................................4
Wheel Chocks..............................................................4
Remove payload from vehicle before lifting. No person(s)
should be in or on the vehicle while lifting.
To raise the entire vehicle, install chocks in front and
behind each front wheel. Center the jack under the rear
frame crossmember. Raise the vehicle enough to place a
jack stand under the outer ends of the rear frame cross-
member.
Lower the jack and test the stability of the vehicle on the
two jack stands. Place the jack at the flat section of the
steering box skid plate.
View from Underside of Vehicle
Front
Frame Rail
Summary of Contents for E-Z-GO Cushman TITAN 36V HD
Page 1: ...Owner s Guide Titan LD HD Electric 635592 B Issued NOVEMBER 2013 Revised JULY 2018...
Page 57: ......
Page 58: ......
