44
1. Speedometer/Tachometer/Condition
Warning Display - Indicates the
approximate vehicle speed (MPH or
km/h) or RPM. Warns of a system
error condition requiring attention.
The LCD will go blank except the
word VOLT will flash on the LCD
whenever a low voltage (<9 DC volts)
or a high voltage (>16 DC volts) is
detected. When voltage returns to nor-
mal, the gauge must be reset by turn-
ing the ignition key to the OFF
position and then to the ON position.
The letters EFI (digital/analog
gauge) or a diagnostic trouble code
(DTC) (digital gauge) will flash on
the LCD whenever an EFI system
error is detected. After 30 seconds,
the gauge will return to normal, but
the letters or code will continue to
flash until the malfunction is cor-
rected.
NOTE: Take the vehicle to an
authorized dealer to have the error
corrected and the system error reset
as soon as possible.
2. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
NOTE: When the bottom segment
flashes, approximately 3.5 L (0.92 U.S.
gal.) of gasoline remains in the tank.
3. Mode Button - Press and release to
shift the gauge between MPH or km/
h and RPM. Press and hold to switch
between MPH and km/h.
4. Set/Reset Button - Press and release
to shift between Odometer, Trip 1,
Trip 2, Engine Hour Meter, and
Clock. Press and hold while Trip 1
or Trip 2 are selected to clear the
selected trip. The odometer cannot
be reset.
5. Odometer/Trip Meter/Clock/Engine
Hour Meter - Displays odometer
(total distance the vehicle has trav-
eled) or one of two trip meters used
to measure trips or trip legs corre-
sponding to the function selected
(MPH or km/h). The clock function
indicates time in the 12 hour mode.
The hour meter indicates the total
time the ATV has run and cannot be
reset to zero. To set the clock, use
the following procedure.
A. With the ignition switch ON, press
and release the Mode Button (3)
until the Clock/Engine Hour
Meter (1) is displayed; then (if
necessary) press and release the
Set/Reset Button (4) to the clock
display.
B. Press and hold Set/Reset Button (4)
until minutes stop scrolling and the
hour display starts to scroll.
Momentarily release when correct
hour is displayed; then repeatedly
press and release Set/Reset Button
until correct minutes are displayed.
NOTE: Approximately two seconds
after releasing either Button, the
LCD will return to normal operation.
NOTE: Clock memory power is
supplied through the 10-amp mem-
ory fuse and verified during gauge
“power-up” and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will “power-
up,” reset, and shut down repeatedly
until clock memory power is
restored. Always check the 10-amp
memory fuse if this gauge condition
is noted.
NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
6. Gear Position Indicator - Indicates
which gear is selected - R (reverse)/
N (neutral)/H (high range)/L (low
range)/P (park).
NOTE: An E will be displayed if
there is an error caused by a no-shift
position signal.
Summary of Contents for ALTERRA MUD PRO 700 LTD EPS 2018
Page 1: ......
Page 71: ...69 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES...
Page 74: ...72 NOTES...
