OPERATION AND SERVICE INFORMATION
Page 8
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Dangers and Warnings
Place the jack at the center of the front axle. Raise the
vehicle enough to place jack stands under the frame
crossmember as indicated.
Lower the jack and test the stability of the vehicle on all
four jack stands.
If only the front or rear of the vehicle is to be raised, place
the chocks in front and behind each wheel not being
raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
Fig. 9 Lifting the Vehicle
WHEELS AND TIRES
Tire Repair
Tool List
Qty. Required
Lug wrench, 3/4" ......................................................... 1
Impact socket, 3/4", 1/2" drive..................................... 1
Impact wrench, 1/2" drive ............................................ 1
Torque wrench, 1/2" drive ........................................... 1
A tire explosion can cause severe injury or
death. Never exceed inflation pressure rating
on tire sidewall.
To reduce the possibility of tire explosion,
pressurize tire with small amount of air
applied intermittently to seat beads. Due to
the low volume of the small tires, overinfla-
tion can occur in seconds. Never exceed
the tire manufacturer’s recommendation
when seating a bead. Protect face and eyes
from escaping air when removing valve
core.
To reduce the possibility of severe injury
caused by a broken socket when removing
wheels, use only sockets designed for
impact wrench use.
Use caution when inflating tires. Overinfla-
tion could cause the tire to separate from
the wheel or cause the tire to explode,
either of which could cause severe injury.
Do not use low inflation pressure tires on any
E-Z-GO vehicle. Do not use any tire which has
a recommended inflation pressure less than the
inflation pressure recommended in Owner’s
Manual.
Use caution when inflating tires. Due to the low volume of
the small tires, overinflation can occur in seconds. Over-
inflation could cause the tire to separate from the wheel
or cause the tire to explode.
Tire inflation should be determined by the condition of the
terrain. See GENERAL SPECIFICATIONS section for
recommended tire inflation pressure. For outdoor appli-
cations with major use on grassy areas, the following
should be considered. On hard turf, it is desirable to have
a
slightly
higher inflation pressure. On very soft turf, a
lower pressure reduces the possibility of tires cutting into
the turf. For vehicles being used on paved or hard sur-
faces, tire inflation pressure should be in the higher
allowable range, but under no condition should inflation
pressure be higher than recommended on tire sidewall.
All four tires
should have the same pressure for opti-
mum handling characteristics. Be sure to install the valve
dust cap after checking or inflating.
The vehicle is fitted with low pressure tubeless tires
mounted on one piece rims; therefore, the most cost
View from Underside of Vehicle
Ref Liv 4S
Summary of Contents for 614212 2010
