Texi Treccia, Operation Manual

Page: 8 / 16

6
TEXI Treccia & Treccia C Matic operation manual
15. POSITION OF THE LOOPER THREAD TAKE-UP
Lower the needle from the highest position and adjust, so that the thread comes off from the highest point of the looper Thre-
ad Take-up (I) when left needle reaches to the middle part of the looper .
The adjustment is made by loosening screw (j) (Fig. 18 & 19)
16. ADJUSTMENT OF THE LOOPER *
Please refer to the below table and Fig. 20.
* Only for Treccia (flat bed)
17. HEIGHT OF THE NEEDLES
When the tip of lLooper comes to the center of the left needle, Looper must
pass 0,5~1,0 mm above the upper end of eye—that is—the height of needle is
set on the basis of Looper. Both—needles and looper should be properly fixed.