UDL-Modem Installation Manual
INS147-2
10
4)
Ask the operator of the
Veritas UDL Software
to perform an upload
from the control panel.
5)
Once the upload is completed ask the operator of the
Veritas UDL
Software
to hang-up and observe that LED returns to its flashing
mode.
6)
Secure the cover of the
UDL-Modem
using the two screws supplied.
7)
Finally replace and secure the cover on the control panel.
Clearing the NVM Security Password
The
Veritas UDL Software
has the option to send a password, which is stored in
the
UDL-Modem’s
NVM. Once the password is set any future communication
attempts from the PC will only be accepted if the password in the PC matches
the password stored in the
UDL-Modem.
The password for the
Veritas UDL
Software
is configured in the modem setup screen, see the on line help for
further details.
%
To clear the NVM password proceed as follows:
1)
Remove power from the
UDL-Modem
by unplugging the 4-wire
harness.
2)
Fit jumper link across J2 (Answer Phone Deferred).
3)
Re-apply the power to the
UDL-Modem
by plugging the 4-wire harness
back on.
4)
Within 5 seconds remove jumper link J2, the LED will flash on and off
three times to indicate that the NVM has been cleared.
5)
Re-fit jumper link to J2 if Answer Phone Deferred is required.
