17
7. Stopping the engine
PROCEDURE
1.
Turn the gas control to a ”low” position and let the engine run for a while.
2. Turn off the machine on the ignition switch.
3.
Turn the fuel tap to the ”off” position
See figures 4, 5, 7 on page 3.
8. Operation
OPERATION
1. When the engine has been started move the choke gradually to the right.
2. Adjust the gas to the requested speed.
NOTE
-
Please draw attention to the following during operation.
-
Exhaustion must not be black. If the exhaustion is black the load is too high or
the engine has not been adjusted correctly.
-
No incorrect noises and vibrations.
-
If these appear turn off the engine and adjust it. Contact your Power Line dealer
9. Sparking plug
PROCEDURE
-
Remove the sparking plug cover.
-
Brush off dirt from the sparking plug.
-
Use a sparking-plug wrench to loosen the sparking plug.
-
Inspect if the isolation is intact.
-
Clean the sparking plug with a steel brush.
-
Measure the electrode distance, make sure not to damage the electrode.
-
The distance should be: 0,7
– 0,8 mm
-
If the sparking plug is okay, put it back in its place.
-
Put the sparking plug cover back in its place.
Closed
Closed
Choke
HIGH
LOW
Ignition switch
Summary of Contents for Power Line TG510
