16
Step 6
: At this point, you should make sure the wires are correctly tightened at the 5 locations
circled in
Figure 5
. It is also very important to make sure the wires are going from
outside of the tube frame to avoid any possible damage of wires by the tray.
Step 7
: Get the tray rack and 2 sets of hex nuts, bolts, and washers ready (Figure 13 & 14).
Insert the bolt and washer into the rack like
Figure 15-1
. Put on the other washer and
nut like
Figure 15-2
. Make sure they are fastened tightly enough (
Figure 15-3
).
Bolt: M16*P2.0*45mm x 2
Inner washer: D21.9*d16*15mm x 2
Nut: M16*P2.0*t12.7mm x 2 Spring washer: D26*d16.5*t3.0mm x 2
Wiring from outer
side of the tube
Figure 12
Figure 14
Figure 15-1
Figure 15-2
Figure 15-3
Figure 13
