Texas CW 250, User Manual, Page: 18 / 30

www.texas.dk
18
2. Safety precaution before use
The submersible pump should always be protected with a safety device (FI <30mA).
Contact an electrician if necessary.
Inspect the pump particularly the electric cable and plug before the pump is started.
Do not connect a defect pump to the power supply. If the pumps is defect contact your
dealer. The pump is mounted with a 10 mtr. long 1 mm
2
electric cable of the type
H05RN-F. Outer diameter 9,5 mm.
Make sure the wire connections are placed dry and safe from flooding.
Plug and electric cable must not come near heat, oil or sharp edges.
Check that the mains voltage corresponds with the voltage stated on the type tag.
Children under the age of 16 must not work with the pump.
Keep children away from the pump.
Make sure there are no twists on the outlet hose.
Note lowest water level (see point 9).
Respect the maximum lift height (see point 9).
Do not replace a damaged electric cable yourself but leave it to the electrician or
dealer.
3. Before use
3.1 Hose connection
Fasten the hose connection (7) onto the pump (see sketch B). Hoses in the dimensions 25
mm (1 ) and 32 mm (1¼ ) can be connected. The hoses shall be pressed on the variable
nipple pipe. It is recommended to ensure the hoses with a clip.
I f a 32 mm (1¼ ) hose is connected, the 25 mm (1 ) part can be cut off with a knife
(sketch E).
The highest pump ability is obtained with a 32 mm (1¼ ) hose.