DAC and ADC GUI Configuration File Changes When Using a Xilinx Development Platform
21
SLAU580B – June 2014 – Revised September 2016
Copyright © 2014–2016, Texas Instruments Incorporated
TSW14J10 FMC-USB Interposer Card
6.2
ADC32RF45EVM With Xilinx VC707 Development Board Setup Example
The following is an example of the TSW14J10EVM being used to test the ADC32RF45EVM with a Xilinx
Virtex VC707 development platform as shown in
.
Figure 13. ADC32RF45EVM, TSW14J10EVM and VC707 Board
The following example shows what must be modified in the ADC32RF45 GUI for a setup using the
JESD204B mode setting of LMFS = 82820 (8 lanes, 2 converters, 8 octets/frame, 20 samples/frame) with
the ADC in bypass mode, and a sample rate of 2G.
Connect the hardware as follows:
1. Connect the TSW14J10 to FMC HPC connector FMC1 on the VC707.
2. Connect the ADC to the other end of the TSW14J10.
3. Connect the power cables to the VC707 and ADC32RF45.
4. Connect a USB cable between the TSW14J10 and a host computer with HSDC Pro GUI loaded.
5. Connect a USB cable between the ADC32RF45 and a host computer with ADC32RFxx GUI loaded.
6. Provide a 600-MHz, 12-dBM filtered IF source to AINP SMA J2.
