Hardware Overview
3
Hardware Overview
If not already assembled, the basic hardware setup for the TMP007EVM involves connecting the TMP007
test board to the SM-USB-DIG and then connecting the SM-USB-DIG to the computer. This section
describes the details of this procedure.
3.1
Typical Hardware Connections
Connect the right-angle female socket on the TMP007 test board to the right angle male header on the
SM-USB-DIG. Take special care to ensure that the two 10-pin sockets directly align with each other. Make
sure that all connectors are properly aligned and pushed together firmly. Loose connections may cause
intermittent operation.
Afterwards, plug the SM-USB-DIG to the computer. A green LED light indicates that the SM-USB-DIG is
powered up, as shown in
. Always connect the two boards together before connecting the USB
cable to avoid any issues if the connectors are misaligned. The device is not operational if the connectors
are misaligned.
Figure 4. Typical Hardware Connection
5
SBOU137A – May 2014 – Revised December 2014
TMP007EVM User's Guide
Copyright © 2014, Texas Instruments Incorporated