EVM Setup
4
SBVU049 – November 2018
Copyright © 2018, Texas Instruments Incorporated
TLV767EVM-014 Evaluation Module
2
EVM Setup
This section describes how to properly connect and setup the TLV767EVM-014, including the jumpers and
connectors on the EVM board.
2.1
Input/Output Connector and Jumper Descriptions
2.1.1
J1 – IN
Input power-supply voltage connector. Twist together the positive input lead and ground return lead from
the input power supply, and keep them as short as possible to minimize input inductance.
2.1.2
J2 – OUT
Regulated output voltage connector.
2.1.3
J3 – IN_S
Input sense.
2.1.4
J4 – OUT_S
Output sense.
2.1.5
J5 – ENABLE
Output enable. To enable the output, connect a jumper to short IN to EN. To disable the output, connect a
jumper between GND and EN.
2.1.6
J6 – GND
Input ground return connector.
2.1.7
J7 – GND
Output ground return connector.
2.1.8
J8 – OUTPUT VOLTAGE Set
For convenience, the EVM is prepopulated with four resistor divider options. Place a shunt on J9 next to
the silkscreen label of your desired output voltage.
2.1.9
TP1 – IN_S
Input sense test point.
2.1.10
TP2 – OUT_S
Output sense test point.
2.1.11
TP3 – EN
Enable test point.
2.1.12
TP4 – GND
Ground test point.
2.1.13
TP5 – GND
Ground test point.
