Texas Instruments mmWaveICBoost, User Manual

Page: 24 / 82

2.7.4 60-Pin High Density (HD) Connector (J10)
This connector enables interfacing of LVDS signals to the to the DCA1000 EVM for data capturing purposes, as
shown in
Figure 2-19 . DIP switch (S1) combinations must be set to ON/OFF, as mentioned in Table 2-1 , before
interfacing to the DCA1000 EVM.
Figure 2-19. 60-Pin HD Connector (DCA1000)
2.7.5 MIPI 60-Pin Connector (J9)
This connector provides the standard MIPI 60-pin interface, as shown in Figure 2-20 for JTAG and trace
capability through emulators such as the XDS560pro. To use this interface, the JTAG lines from the onboard
emulator (XDS110) and 14-pin JTAG connector must be disconnected; this is done with S1 (12th position of dip
switch should be open), and the JTAG Debugger should not be connected on the 14-pin connector.
Figure 2-20. 60-Pin MIPI Connector
MMWAVEICBOOST www.ti.com
24 mmWaveICBoost and Antenna Module SWRU546D – OCTOBER 2018 – REVISED NOVEMBER 2020
Submit Document Feedback
Copyright © 2020 Texas Instruments Incorporated