3 Quick Start Guide
The MCF8315EVM requires a power supply source, which has a recommended operating range from a 4.5-V to
35-V. To setup and power the EVM, follow the sequence below:
1. Connect motor phases to A, B, C on connector J8.
2. Do not turn on the power supply yet. Connect motor supply to VBAT/VM and PGND on connector J7.
a. To enable reverse polarity protection and Pi filter, connect to VBAT. Note that when connecting to VBAT,
VM will be VM – 0.7 V less, due to a diode drop in the reverse-polarity protection circuit.
b. To disable reverse-polarity protection and the Pi filter, connect to VM.
3. Select J3 to 5V_USB and J5 to 3V3COM to power MSP430 from USB power supply.
4. Connect the micro-USB cable into the computer.
5. Turn the potentiometer fully clockwise to set the motor to zero speed upon powerup.
6. Flip the switch S1 to the right to configure BRAKE = RUN, switch S2 to the left to configure DIR = ABC, and
switch S3 to the right to configure DRVOFF = ON
7. Turn on the motor power supply.
8. Use the potentiometer R4 to control the speed of the motor and the switches to disable the motor driver,
change the direction, or apply a brake to the motor. Optionally, use the GUI (as shown in
) to monitor real-time speed of the motor, put the MCF8315 into a low-power sleep mode, and
read status of the LEDs.
Figure 3-1. Reference for Quick Start Guide
Quick Start Guide
4
MCF8315EVM Evaluation Module
Copyright © 2022 Texas Instruments Incorporated
