Texas Instruments LM63635DNEVM, User Manual, Page: 3 / 16

1 Setup
This section describes the test points and connectors on the EVM and how to properly connect, set up, and use
the LM63635DNEVM. Either the banana jacks on the top of the board or the card edge connector can be used
for connections. See
Figure 1-1 for the top of board connections and Figure 1-2 for the card edge connections.
See the LM636x5-Q1 3.5-V to 36-V, 1.5-A, and 2.5-A Automotive Step-down Voltage Converter Data Sheet for
details. The following lists the functions of the connections:
VINEMI Input supply to EVM. Connect to a suitable input supply.
GND System ground.
VOUT Output of EVM. Connect to desired load.
VOS Output voltage sense connection (do not use for power; sense only).
VIS Input voltage sense connection (do not use for power; sense only).
GNDS Ground sense point for analog measurements (do not use for power; sense only).
LOAD
Input Power
Supply
Output
Voltage
DMM
Input Voltage
DMM
(+)
(-)
(+)
(-)
(+)
(-)
(+)
(-)
Figure 1-1. EVM Board Connections
www.ti.com Setup
SNVU767 – MARCH 2022
Submit Document Feedback
LM63635DNEVM EVM User’s Guide 3
Copyright © 2022 Texas Instruments Incorporated