Texas Instruments LM63635DNEVM, User Manual, Page: 4 / 16

GND VOUT
G
N
D
S
VOS
TOP FRONT
BOTTOM FRONT
VIS
VINEMI
INPUT
SUPPLY
LOAD
(+) (-) (-) (+)
(+)
(-)
DMM
DMM
(-) (+)
(+) (-)
CM Choke
Input *
* = Optional Connections
Input
Voltage
Output
Voltage
Figure 1-2. EVM Card Edge Connections
1.1 Jumpers
See Figure 1-3 for jumper locations.
MODE This jumper allows the selection of either AUTO mode or FPWM mode. In addition, by removing this
jumper and supplying a clock signal to the SYNC/MODE test point, the device can by synchronized to
an external clock.
EN This jumper turns the device on or off. In addition, by removing this jumper and supplying a signal to the
EN test point, the device can be controlled externally.
Mode Selec on
Jumper
EN Control
Jumper
Figure 1-3. Jumper Locations
Setup www.ti.com
4 LM63635DNEVM EVM User’s Guide SNVU767 – MARCH 2022
Submit Document Feedback
Copyright © 2022 Texas Instruments Incorporated