After inputting the LED values to be set click on the “SET Report” button and the LEDs on board will
turn on.
Test Passes if LED’s turn on.
If LED’s do not turn on follow the following steps:
Step1: In the code composer studio ensure the program is running. If it was not running Proceed to
Step 3 else proceed to step 2.
Step 2. Press the pause button.
Step 3. Press the reset CPU button
Step 4. Press the Play button
After completing these four steps return to the beginning of section 7.9.0
8
EQUIPMENT SHUTDOWN
Disconnect the Launchpad from the PC before disconnecting the Power supply from the EVM.
9
Final Jumper locations after Test
Jumpers should be installed according to the following table.
Reference Designator
Installed (Y/N)
P12
Yes
P13
Yes
P14
Yes
P15
Yes
P16
10
MATERIAL DISPOSITION & TRANSFER
10.1.0
Conforming Material
Units that have passed this test procedure shall be packaged into anti-static ESD approved bags, labeled with
the labels according to the table below, and shipped per the P.O.
Label 1
Assembly Dash Number if
Applicable
Label 2
IC Number
HVL038A
TCA8424RHAR
