1
3
4
2
A
1 2 3
4
MINI
ALP Software Setup
14
SNLU232A – August 2018 – Revised May 2019
Copyright © 2018–2019, Texas Instruments Incorporated
DS90UH949A-Q1EVM or DS90UB949A-Q1EVM User's Guide
1.11 ALP Software Setup
1.11.1 System Requirements
Operating System:
Windows 7 64-bit
USB:
USB2ANY
USB2ANY Firmware Version:
2.5.2.0
1.11.2 Download Contents
TI Analog LaunchPAD can be downloaded from:
.
Download and extract the “snlc048.zip” file to a temporary location that can be deleted later.
Make sure J34 on the DS90Ux949A-Q1EVM is connected to a PC USB port with USB cable and power is
applied to the DS90Ux949A-Q1EVM.
The following installation instructions are for the Windows 7 64-bit Operating System.
1.11.3 Installation of the ALP Software
Execute the ALP Setup Wizard program called “ALPF_setup_v_x_x_x.exe” that was extracted to a
temporary location on the local drive of your PC.
There are 7 installation steps after the setup wizard starts:
1. Click the "Next" button in the ALP Setup Wizard to start the installation.
2. Select “I accept the agreement” and then click the “Next” button.
3. Select the location to install the ALP software and then click the “Next” button.
4. Select the location for the start menu shortcut and then click the “Next” button.
5. Create the desktop icon on the next screen. After selecting the desired choices, click the “Next” button.
6. Click the “Install” button to install the software in the selected location.
7. Uncheck “Launch Analog LaunchPAD” and click the “Finish” button. The ALP software can start if
“Launch Analog LaunchPAD” is checked, but it will not be useful until the USB driver is installed and
board is attached.
Connect the J34 USB jack of the DS90Ux949A-Q1EVM board to a PC or laptop USB port using a Type A
to mini-B
USB cable. Power the DS90Ux949A-Q1EVM board with a 12-VDC
power supply to launch the “Found New Hardware Wizard” on the PC or laptop.