Setup
9
SNLU213A – October 2016 – Revised September 2019
Copyright © 2016–2019, Texas Instruments Incorporated
DS280MB810EVM User’s Guide
9. In order to view a high level summary of the device status and control settings, navigate to the “High
Level Page," and remain on the “Device Status tab” as shown below in
. Click “Refresh From
Device” to ensure the settings shown are from the device. The settings on this page are not editable.
•
Signal Detect Status:
For each channel the device status is displayed as “Signal Not Detected” if
there is not a signal present at the RX side of this channel or “Signal Detected” if there is a signal
present at the RX side of this channel.
•
Driver Power:
The Driver Power can be turned on or off and the current status is displayed on the
Device Status page. The Driver Power is detected at the TX side of each channel.
•
Control Settings:
The remaining control settings are programmable through SigCon Architect.
The displayed values are the current settings programmed on the device. Step 10 describes how
to edit these settings.
Figure 7. SigCon Architect High Level Page: Device Status.