Setup
8
SNLU213A – October 2016 – Revised September 2019
Copyright © 2016–2019, Texas Instruments Incorporated
DS280MB810EVM User’s Guide
Figure 5. SigCon Architect Configuration Page.
8. In order to read and write to all registers on the DS280MB810, navigate to the “Low Level Page," as
shown below in
. Only in SMBus Slave Mode can the user read and write to all programmable
registers. Click “Read All” in order to load the data in each register from the device to the “Register
Map."
•
Read Register:
Type the readable address in the “Current Address” text box. Click “Read
Register." The data in this register will appear in the “Data” text box.
•
Write Register:
Type the writable address in the “Current Address” text box, and type the data to
write to this address in the “Data” text box. Click “Write Register.”
Figure 6. SigCon Architect Low Level Page.