Texas Instruments DLP5534PROJQ1EVM, User Manual

Page: 9 / 13

www.ti.com
User Guide Overview
9 DLPU097 – November 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
DLP5534PROJQ1EVM Evaluation Module User's Guide
1.2.3 Component Temperature Ratings
The PCB materials and most of the PCB components are rated to operate between –40°C to 105°C,
including the DLP5534-Q1, the DLPC230-Q1, and the TPS99000-Q1.
Some components on PCBs, such as switches, connectors, and indicator LEDs, do not meet this
temperature rating. The specifications for EVM components which are not rated between –40°C to 105°C
are listed in
Table 8 . Please refer to the EVM bill of materials to review the temperature specifications of
all components used in the EVM design.
Table 8. EVM PCB Components Which are Not Rated for –40°C to 105°C
Board Reference Part Number Manufacturer Description
Temperature
Minimum (°C)
Temperature
Maximum (°C)
Controller D4, D5 LTST-C171KGKT Lite-On LED, GREEN 0805 –55 85
Controller D6 LTST-C171KRKT Lite-On LED, RED 0805 –55 85
Controller J3 685119248123 Wurth
CONN MICRO HDMI
RIGHT ANGLE
–40 85
Controller SW2 CVS-03TB Copal Electronics Inc
SWITCH DIP SLIDE 3-
POS 1 MM 6 V
–40 85
Controller SW1,SW3 CVS-01TB Copal Electronics Inc
SWITCH DIP SLIDE 1-
POS 1 MM 6 V
–40 85
Controller SW4 GT12MSABETR C&K Comp SWITCH, SPST, GULL –30 85
Controller
U5, U7,
U10, U503,
U504
PCMF2HDMI2SZ Nexperia
COMMON MODE
CHOKE 4LN SMD ESD
–40 85
Controller U501 TFP401AIPZPRQ1 Texas Instruments
IC PANELBUS DVI
RCVR 100-HTQFP
–40 85
The Controller and Illumination Driver PCBs have a UL flame rating of 130°C maximum.
1.2.4 Input Video Specifications
The following input video resolutions are supported on the HDMI and OpenLDI interfaces. These input
video resolutions are programmed in the Extended Display Identification Data (EDID) EEPROM for the
EVM's HDMI interface allowing a connected computer to read the supported resolutions and timing. Note
that some computers may not be able to output all of these resolutions, in particular 576 × 288.
• 1152 × 1152
• 1152 × 576
• 576 × 288
The recommended input source timings for the EVM's HDMI interface are specified in the DLPC230-Q1
data sheet. These timing parameters are also recommended for the OpenLDI interface.
1.2.5 SPI and I
2
C Timing
For more information on SPI and I
2
C specifications, see the DLPC230-Q1 data sheet.