Texas Instruments DAC53608, User Manual

Page: 8 / 31

System Setup
www.ti.com
8 SLAU790A – October 2018 – Revised December 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
DAC53608 Evaluation Module
Table 5. BOOSTXL-DAC-PORT Jumper Settings (continued)
Jumper Default Position Available Option Description
J10 1-2: 3.3V from Launchpad 2-3: External VIO 3.3V or External VIO
J11
Closed: DAC_VIO is connected to
VIO
Open: DAC_VIO OFF DAC_VIO ON/OFF
2.2.2 Connecting the Hardware
Once the Analog EVM Controller firmware is upgraded as described in Section 2.1.3 and power and
jumper configurations done as per Section 2.2.1 , the BOOSTXL-DAC-PORT, and DAC53608EVM can be
connected as shown in Figure 6 . Connect the USB cable from the Analog EVM Controller DEBUG Port
(U7) to the PC.
Figure 6. Hardware Setup Guidelines
2.2.3 Electrostatic Discharge Warning
Many of the components on the DAC53608EVM are susceptible to damage by electrostatic discharge
(ESD). Observe proper ESD handling precautions when unpacking and handling the EVM, including the
use of a grounded wrist strap at an approved ESD workstation.