Texas Instruments DAC53608, User Manual

Page: 6 / 31

System Setup
www.ti.com
6 SLAU790A – October 2018 – Revised December 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
DAC53608 Evaluation Module
Figure 3. TI Cloud Agent Installation
• Press the Refresh or Finish button after the installation. This should detect the Launchpad
• Press Start and browse for "<Download
Directory>\DAC53608EVM_1.0.1_installer_win\install_image_DAC53608EVM\DAC53608EVM\firmwar
e\acctrl.0.3.0.3.bin"
. Press Load Image followed by Verify Image
• Once the firmware is loaded, remove the USB cable from the XDS110 port and connect to the port U7
as shown in step 4 of
Figure 4 . U7 is available near the RJ-45 connector on the board
• Open Control Panel-->Device Manager and you will find two new ports, probably with the name of
Virtual COM Port or some other generic names
• Right click on each one and select Update Driver and link them to the driver file inside the "<Download
Directory>\DAC53608EVM_1.0.1_installer_win\install_image_DAC53608EVM\DAC53608EVM\driver"
directory. This will enumerate the ports as ACCtrl and ACCtrl Console inside Ports (COM & LPT) . The
serial port connection is done to the ACCtrl port as discussed later in the document.
Figure 4. Analog EVM Controller Setup