Registers
17
SLUUBQ2C – July 2017 – Revised April 2019
Copyright © 2017–2019, Texas Instruments Incorporated
Getting Started with the BQ79606A-Q1 GUI
To enable SPI across GPIO3-GPIO6, check the “Enable SPI” checkbox provided (#1 in
). Ensure
the desired settings for CPOL, CPHA, SS, and SPI Transaction length (1 to 8 bits long) are correct. There
is loopback functionality provided by the “Enable Loopback” checkbox, as well as boxes for
transmitting/receiving the SPI data (#2 in
). You may send 1 byte of data over SPI by writing the
desired byte in the “SPI Transmit” box, in hex (#3 in
). Then use the “Execute SPI (Single Device
Only)” button to send/receive the data (#4 in
Figure 22. SPI Master Configuration
7
Registers
7.1
Bit Level Register Map
Displays a register map of all user addressable registers in the BQ79606A, as well as allowing for bit level
read and writes.