www.ti.com
Test Summary
7
SLUUBT8A – June 2018 – Revised July 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
BQ2571x Evaluation Module
7. Install jumpers as “JUMPER SET UP”.
After completing these steps , the test setup for BMS017 is as shown in
Figure 2
.
Figure 2. Original Test Setup for BMS017 (BQ2571x EVM)
8. Turn on the computer and power supply #1. Open the BQstudio software.
a. Select
Charger
and click the
Next
button.
b. For SMBus BQ25710, select “Charger_1_00-BQ25710SMB.BQz” on the
Select a Target Page
. For
I
2
C BQ25713, select “Charger_1_00-BQ25713I2C.BQz” on the
Select a Target Page
.
c. After selecting the target device, change “update mode” from “immediate” to “manual”, click “Read
Register” and the following interface is presented.
