Texas Instruments BOOSTXL-CC3135, User Manual

Page: 19 / 22

www.ti.com
Connecting to the PC Using CC31XXEMUBOOST Board
19 SWAU106 – January 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
CC3135 SimpleLink™ Wi-Fi
®
BoosterPack™ Development Kit (BOOSTXL-
CC3135)
3.4 Jumper Settings on the CC31XXEMUBOOST Board
Table 7 specifies the jumpers to be installed while pairing with the CC31XXEMUBOOST board.
Table 7. Jumper Settings on the CC31XXEMUBOOST Board
No Jumper Settings Notes
1 J4 (short) Provides 3.3 V to the BoosterPack™
2 J22 (short) Provides 5.0 V to the BoosterPack™
3 J3 (1 to 2) Routes the NWP logs to the dual port also
The remaining jumpers can remain open.
4 Connecting to a LaunchPad™ Kit
The CC3135 BoosterPack™ module can be directly connected to a compatible LaunchPad™
development kit using the standard two 20-pin connectors. The jumper settings needed for this connection
are the same as those needed for the CC31XXEMUBOOST board, as described in
Section 3.3 .
Ensure that pin 1 of the two 20-pin connectors are aligned correctly before pairing. Figure 14 shows the
connected setup. The USB cable is directly connected to the BoosterPack module to power it only. For
debugging, the USB cable on the LaunchPad kit is also required.
Figure 14. CC3135BP Connected to MSP432™ LaunchPad™ Kit