Connecting to the PC Using CC31XXEMUBOOST Board
18
SWAU106 – January 2019
Copyright © 2019, Texas Instruments Incorporated
CC3135 SimpleLink™ Wi-Fi
®
BoosterPack™ Development Kit (BOOSTXL-
CC3135)
3.2
Connecting the Boards
shows the connection of the CC3135 BoosterPack™ module to the CC31XXEMUBOOST
board. The connectors must be aligned carefully, because the CC31XXEMUBOOST board does not have
polarity protection, and the serial flash can be erased as a result. Pin 1 on each of the connectors is
marked on the board using a small triangle marking; these pins must be aligned while connecting.
Figure 13. BOOSTXL-CC3135 Connected to the CC31XXEMUBOOST Board
CAUTION
Align pin 1 of the boards together using the triangle marking on the PCB. An
incorrect connection can destroy the boards permanently.
Ensure that none of the header pins are bent before connecting the two boards.
3.3
Jumper Settings on the BOOSTXL-CC3135 Board
specifies the jumpers to be installed on the BOOSTXL-CC3135 before pairing with the
CC31XXEMUBOOST board.
Table 6. BOOSTXL-CC3135 Jumper Settings
Number
Jumper Settings
Notes
1
J8 (1-2)
Powers the BoosterPack™ from the CC31XXEMUBOOST board. The jumper
shall be placed so that it is near the edge of the PCB.
3
J6 (short)
No current measurement.
