Texas Instruments BMS026, User Manual

Page: 2 / 24

Introduction
www.ti.com
2 SLUUC73 – March 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
BQ25616, BQ25616J BMS026 Evaluation Module
1 Introduction
1.1 EVM Features
For detailed features and operation, refer to Table 1 for a list of devices and their data sheets.
Table 1. Device Data Sheets
Device Data Sheet EVM Label Variant
BQ25616 SLUSDF7 BQ25616EVM 001
BQ25616J SLUSDF7 BQ25616JEVM 002
The BMS026 evaluation module (EVM) is a complete charger module for evaluating the standalone single-
cell NVDC charger using any of the devices above.
This EVM features adjustable input current limit, charging current, and charging voltage. It also has the
abilty to test the D+/D- input source type detection, external input over-voltage protection, and simulate
battery high and low temperature conditions.
1.2 I/O Descriptions
Table 2 lists the input and output connections available on this EVM and their respective descriptions.
Table 2. EVM I/O Connections
Jack Description
J1(2) – VAC Positive rail of the charger input voltage
J1(1) – GND Ground
J2(1) – SYSTEM Positive rail of the charger system output voltage, typically connected to the
system load
J2(2) – GND Ground
J3(1) – PMID Positive rail of the charger output voltage for power bank applications in
reverse boost mode (OTG). This output also shares the rail with the VIN
input rail in forward buck mode
J3(2) – GND Ground
J4 Input source Micro B USB port
J5-BATSNS_ICHG BATSNS or ICHG pin connection
J5(3) – ICHG ICHG pin external connection
J5(2) – BATTERY Positive rail of the charger battery input, connected to the positive terminal of
the external battery
J5(1) – GND Ground
J6 USB2ANY 10-pin connector
J7 I2C 4-pin connector for the EV2300/2400 interface board
Table 3 lists the jumepr, shunt and switch installations available on this EVM and their respective
descriptions.
Table 3. EVM Jumper, Shunt and Switch Installation
Jack Description BQ25616 Setting BQ25616J Setting
JP1 VBUS additional capacitance connection Not Installed Not Installed
JP2 SYS additional capacitance connection Not Installed Not Installed
JP3 PMID additional capacitance connection Not Installed Not Installed
JP4 BAT additional capacitance connection Not Installed Not Installed
JP5 I/O Pullup rail selection. Selection will have
either BAT or SYS as the pullup rail for /CE,
STAT, OTG, and /PG pins Short PULLUP to
SYS
Short PULLUP to
SYS