Texas Instruments AFE7222EVM, User Manual

Page: 12 / 23

The section controls the setup of the digital
interface as well as test modes and digital
features such as decimation and loopback
The general setup tab includes
controls for the digital RX interface
RX Setup
www.ti.com
6.6 Decimation on the ADC
On the receive channels of the AFE722x, the output can be decimated by 2x using the on-chip FIR
halfband filter. This has no impact on the clock requirements to the AFE722x
– it merely reduces the
output data rate by a factor of 2x and settings (sampling and input frequency) on the TSW1200 capture
card or other data capture tool need to adjusted accordingly.
7 RX Setup
The RX section of the AFE722x is controlled on two
separate tabs of the EVM software.
In the ‘ General Setup ’ tab are the control registers for
the digital interface such as CMOS or serial LVDS
output for example. In order to use the TSW1200 to
capture the received data the following register settings
are required:
Register Bit Setting
Interface Serial LVDS
Master Override Enabled
Format Offset Binary
Serial LVDS 2 Wire
Data Orientation MSB First
DSR Mode Disabled
Wordwise Output Disabled
Bitwise RX Disabled
Halfrx in 2wire Disabled
This tab also controls the register to set the digital
interface to test pattern mode and custom patterns can
be loaded as well. Furthermore RX decimation settings
as well as TX RX loopback mode are controlled here as
well.
12 EVM Description SLOU330 – December 2011
Submit Documentation Feedback
Copyright © 2011, Texas Instruments Incorporated