![background image](http://html1.mh-extra.com/html/texas-instruments/ads8668/ads8668_user-manual_1095237013.webp)
ADS86xxEVM-PDK Initial Setup
Table 13. Default Jumper Configuration
Jumper
Default Position
J2
Closed
J3
Open
J4
Closed
J5
Open
J6
Open
J8
Closed between pins 2 and 3
J9
Closed between pins 1 and 2
J10
Closed between pins 2 and 3
J11
Closed between pins 1 and 2
J12
Closed between pins 1 and 2
J13
Closed between pins 2 and 3
J14
Closed between pins 1 and 2
J15
Open
J16
Closed
J17
Closed
J21
Closed
J22
Closed
J23
Closed
J24
Closed
J25
Open
J26
Closed
J27
Closed
J28
Closed
J29
Closed
J30
Open
J31
Open
6.2
Software Installation
This section presents the steps required to the install the software.
NOTE:
Ensure the microSD memory card included in the kit is installed in the microSD socket (P6)
on the back of the simple capture card before connecting the EVM to the computer.
Otherwise, as a result of improper boot up, Windows
®
cannot recognize the ADS86xxEVM-
PDK as a connected device.
Complete the following steps to install the software:
1. Verify the microSD memory cards are installed on the simple capture card and the ADS86xxEVM
board.
2. Verify jumpers are in the factory-default position and are properly connected to the hardware.
3. Install the ADS86xxEVM-PDK software.
4. Complete the
simple capture card
device driver installation.
Each task is described in the following subsections.
13
SBAU245A – June 2015 – Revised July 2015
ADS86xxEVM-PDK Evaluation Module
Copyright © 2015, Texas Instruments Incorporated