9.2
Setting Up the ADS1274EVM-PDK
www.ti.com
ADS1274EVM-PDK Kit Operation
The ADS1274EVM-PDK contains both the ADS1274EVM and the MMB0 motherboard; however, the
devices are shipped unconnected. Follow these steps to set up the ADS1274EVM-PDK.
Step 1.
Unpack the ADS1274EVM-PDK kit.
Step 2.
Set the jumpers and switches on the MMB0 as shown in
.
•
Set the Boot Mode switch to USB.
•
C5V and +5VA on jumper block J13 (if +5V is supplied from J14 +5VA).
•
Leave +5V and +VA disconnected on jumper block J13.
•
If the PDK will be powered from an AC adapter, connect J12. If the PDK will be powered
through the terminal block, disconnect J12. (See
for details on connecting the
power supply.)
Figure 9. MMB0 Initial Setup
SBAU134A – August 2008 – Revised May 2009
ADS1174EVM, ADS1274EVM, ADS1174EVM-PDK, and ADS1274EVM-PDK
13