18
6. Chain lubrication
The chainsaw is equipped with an automatic lubrication system, which ensures the chain
is always lubricated optimally. However, the system depends on chain oil in oil tank and
regular cleaning
Important
: The chainsaw is not supplied filled with oil. It is essential to fill with
oil before use. Never operate the chainsaw without chain oil or at an empty oil
tank level, as this will result in extensive damage to the product.
Chain life and cutting capacity depend on optimum lubrication. Therefore, the chain is
automatically oiled during operation via oil outlet.
Filling chain oil in tank:
1. Set chainsaw on any suitable surface with oil filler cap facing upward.
2. Clean area around the oil filler cap with cloth and unscrew cap.
3. Do not remove filter insert during filling.
4. Add chainsaw oil until reservoir is full.
5. Avoid dirt or debris entering oil tank, refit oil filler cap (6) and tighten.
Important
: To allow venting of the oil reservoir, small breather channels are
provided between the oil filler cap and the strainer. To prevent leakage, ensure
machine is left in a horizontal position (oil filler cap facing up) when not in use.
Use only the recommended chain oil (ALCO SAE 30 or
similar with viscosity 120) to avoid damage to the
chainsaw. Never use recycled/old oil.
Use of non-approved oil will invalidate the warranty.
Check oil level gauge (9) prior to starting and regularly
during operation. Refill oil when oil level is low.
The oil tank filling will last approx. 16 minutes,
depending on sawing intensity and stops.
To test the oil lubrication, apply half speed on chain.
Check that the chain oil sprays out as shown in
the illustration.
If no oil comes out, check that there is oil in oil tank and make
sure the guide bar groove and holes are free from dirt. Also
clean around the oil outlet behind the bar on machine.
