DISCLAIMER: Tents should always be staked down with Premium Tent Stake Kit and weighed down. Tents should not be used in inclement
weather, including thunderstorms, heavy rains, lightning, and high winds. No grill or any type of open flame is to be used under or near the
tent. User must read and observe assembly instructions. If this is not done correctly, it may result in damage to the unit, injury, or death, and
all warranties will be void. All warranties will be void if hardware is used with any print not produced by us. Properly care for prints to keep
them in great condition. Prints should never be dragged along the ground or stored without being properly folded and free from moisture.
Make sure print is completely dried from any weather, and fold and store in a clean, dry place. We don’t recommend storing print on frame.
ASSEMBLY OF WALL(S) - OPTIONAL
EVENT TENT BASIC
Assembly Instructions
R1.042716
ASSEMBLY OF HALF WALL(S) - OPTIONAL
1. When adding the tent wall(s), the legs of the frame
must be at their maximum extension height.
2. Attach the wall’s loop adhesive to the hook adhesive on
the tent valance.
3-4. Secure the sides of the wall by wrapping the
hook-and-loop adhesive tabs around the tent legs.
5-6. If the tent wall features zippers, walls can be connected
by closing the zipper from bottom to the top.
NOTE: If attaching two or more half walls, you must
stagger the height of the adjoining half walls
or use a 90° corner clamp.
1. Slide one support pole with the click button into the
center support pole. Once the button snaps through
the first hole, repeat this step with the second pole.
Slide the half wall support bar through the print’s pole
sleeve. The support bar should go through the entire pole
sleeve, with both ends of the pole sticking out from either
end of the half wall.
2-3. Attach the half wall clamps. Unscrew the knobs
completely from the clamps and slip the clamps around
the tent legs.
4. Place the appropriate end of the half wall support bar
through the opening of the clamp. Place the tightening
knob into the open holes and hand tighten the knob.
Repeat this step with the second clamp and support pole.
5-6. Secure the hook-and-loop adhesive tabs of the half wall
around the tent legs.
1.
3.
4.
5.
6.
2.
1.
3.
4.
5.
6.
2.