pic. 1
pic. 2
pic. 3
pic. 4
I II III
III
III
II
II
I
pic. 5
at least work load
at least work load
Min. 5x rope diameter
Fully equip the harness for the task to be
performed, then hang in suspension on ground level.
Min. 5x rope diameter
IV
pic. 6
2.3. HOW TO PUT ON
tree
MOTION
evo
Check that the waist belt and leg loop
buckles are undone (1, 9)
2.4. ... AND OBTAIN A GOOD FIT
1) Adjust waist belt webbing (1) and
stow the end under the elastic loop.
2) Adjust webbing in each leg loop (17)
and stow the end under the elastic
loops.
3) Adjust webbing in the adjustable
links (5) and stow the end under the
elastic loops
d) Securely close
the leg loop
buckles (9)
c) Securely close
the waist belt
buckle (1)
a) Hold the
harness by the
back support
b) Step inside
the rope bridge
(10) and the leg
loops (17)
4) Adjust the length of the rope bridg-
es supporting the rope bridge at-
tachment point ensuring the stopper
knots are properly tied, dressed and
set before going ‘on rope’. The ring
is usually fixed to both rope bridges
simultaneously. The rope bridges
should be of equal length. They are
there for redundancy so that if one
rope bridge is e.g. cut, the other one
will take over.
It is also possible to use the ring on
one rope bridge only. A rope bridge
without ring or swivel must not be
used. Alternatively one ring may be
9
Use
