• System 10 THX Ultra 2
9
Connecting
Danger
Danger of injury/damage!
Arrange the cables so that they do not pose a
trip hazard.
• Pull the mains plug of your AV receiver out of the
socket to prevent accidental activation.
Subwoofer
• Ideally, the subwoofer is connected to the subwoofer
jack of the AV receiver with a mono RCA cable.
• Normally, only the RCA jack
1
“LEFT MONO” on the
back side of the subwoofer is used for this purpose.
• The RCA jack
1
“RIGHT” is only occupied if you use
a Y adapter for the connection. This increases the
subwoofer level slightly.
• You will find more information on this in the operating
instructions of your receiver.
• If your receiver does not have a connection for a
subwoofer, connect an available speaker outlet with an
RCA jack
1
of the subwoofer using a voltage reducer
and an RCA cable. We offer voltage reducers on our
website in the “Accessories” area.
Speakers
• Lay the speaker cables from your AV receiver to each
of the speakers. This cable should be high-quality
double-wire speaker cable with marked strands. The
diameter should amount to at least 2.5 mm
2
.
Tip: Label the cables on the receiver side – this will
help when taking down and setting up the receiver.
• A connector terminal with two terminal clips is located
on the back side of each speaker. You can connect the
speaker cables directly or using pin plugs. We only
describe the direct connection here.
• The terminal clips are each marked red (+) and black (-).
Make sure that the polarity is correct!
Connect the like coloured terminals with one
another. Otherwise the sound quality will suffer.
The speaker connectors of your AV receiver should
have similar markings. The strands of the speaker ca-
bles are marked with different colours or shapes.
S 10000 SW THX® Ultra2TM
