13
Frequently Asked Questions
You can find a full list of frequently asked
questions as well as a detailed online
manual online at:
http://manual.raumfeld.com.
General questions
Question 1:
Where can I find internet
radio?
ĕ
TuneIn offers you free access to a wide
range of internet radio stations from all
over the world.
For radio stations which are tailored
specifically to your own taste of music, try
the music service Last.fm (registration is
required but allows you a non-binding test
period and 30 free music titles).
Question 2:
Can I try out the music
services Napster and simfy?
ĕ
The music services Napster and simfy
each offer a 30-day test period of their
premium service, during which you can
listen to all titles available from that
provider in full and for free. The test
period is absolutely non-binding, you do
not enter into any obligation. For simfy,
you need to register to make use of the
test period, while Napster offers an
anonymous test period.
Question 3:
What is an active and a
passive speaker?
ĕ
The active speaker is the one which
contains the amplifiers for both spea-
kers (Master-Box). It also includes the
power connection and Wi-Fi antenna. The
passive speaker (Slave-Box) is connected
to the active speaker via a speaker wire.
Question 4:
How can I stream the Line-in
signal of the Cube to other Raumfeld
devices?
ĕ
When there is a signal on the
analogue audio input of the Cube it is
directly played on the Cube, assuming no
other stream is played back. Should you
wish to stream the signal to other Raum-
feld devices simply go to “Line-in” in
the main menu and select the Cube. The
signal will then be streamed to the current
music zone. Please note that the streaming
causes an audible delay.
System requirements
Question 1:
What system requirements
need to be in place?
• Your Wi-Fi router must have DHCP
enabled.
• IP-addresses should be distributed to
new devices automatically.
If this is not the case, look into the
administration software of your router
and make sure all Raumfeld devices
are assigned a fixed IP address.
• If you are setting up a system without
the Raumfeld Base (see page 10),
your Raumfeld devices are connected
with your own Wi-Fi network. In this
case, your Wi-Fi router (802.11g/n)
needs to be WPA/WPA2-encrypted
or unencrypted.
• If you are setting up a system with the
Raumfeld Base, make sure that your
router is connected to the network
socket of the Base on the right, the
one which is labelled “ROUTER”.
