9
• LT 5A FR
Connecting the Speakers
Due to differing customer requirements, the
LT 5A FR speakers are shipped without speaker
cables. You can find suitable cables in our webshop
(www.teufelaudio.com) in the “Accessories” area.
• The connector terminal with 4 pole terminals is
located on the back of the speaker. You can con-
nect the speaker cable directly or using pin plugs
or cable shoes from our product assortment. The
terminals are marked in red (+) and black (-).
Make sure the polarity is correct!
Connect the like coloured terminals with one
another. Otherwise, the sound quality will suffer.
The speaker connections of your amplifier should
be marked similarly. The individual strands of the
speaker cables are marked with different colours or
shapes.
1. Turn off your ATMOS amplifier/AV receiver.
2. Lay the speaker cable from each speaker to your
amplifier. For each speaker, you will need
– a speaker cable for the normal, passive part to
the connector SPEAKER IN (7) and
– either another speaker cable for the ATMOS
module to the HIGH LEVEL IN - HEIGHT connec-
tor (6) or
– a mono RCA cable for the ATMOS module to the
LOW LEVEL IN - HEIGHT connector (5).
3. If you use a speaker cable with pin plugs or cable
shoes from our product range, simply insert the
pin plugs in the like-coloured connector terminals.
Cable shoes are slid under the terminals and
clamped in place.
4. If you use speaker cables without plugs, split the
single wires down to approx. 30 mm on both ends
and remove approx. 10 mm of the insulation on
each end. Twist the stripped cable ends so that no
strands are protruding.
5. Connect the terminals as follows:
ATMOS RCA output of
the amplifier/AV receiver
(Front) speaker output of
the amplifier/AV receiver
ATMOS speaker output
of the amplifier/AV
receiver
or
Use the input
Low-Level-In (5)
, when your
amplifier/AV receiver has a line-out output for
height speakers.
If your amplifier/AV receiver only has amplifier output
(high level out), use the input
High-Level-In (6)
.
If both outputs on your amplifier/AV receiver are
available, you should use the input
Low-Level-In (5)
.
6. Turn the connector terminals counterclockwise
until loose.
7. Insert the stripped cable ends in the holes that
are now visible. Now turn the terminals clockwise
to close them. The cables are now clamped in
place.
8. Connect the other end of the cables to your
amplifier/AV receiver. You should be able to find
corresponding notes in the user manual of your
device.
9. Insert the round connector of the mains adapter
h
in the POWER jack (1).
10. Connect the mains cable
i
to the mains adapt-
er and insert the mains plug into a socket.
11. Switch your ATMOS amplifier/AV receiver back on.
