• Impaq® 3000 Mk 2 Blu-ray
13
Sensor buttons
The buttons on the front side of the receiver are sensor
buttons: Gently touching them is enough to trigger a
switch operation.
Activating and deactivating
• You can switch your receiver to operational mode or
standby mode with the button
15
or
69
“ ”.
• The red LED
11
is on in standby mode.
Standby does not disconnect the device from the mains.
To turn it off completely, pull the power plug out of the
socket.
Selecting a source
After turning the device on, the last source device se-
lected is activated.
• You can change the source in this order with the button
2
“SRC”:
DISC (BD/DVD/CD and USB), HDMI 1, HDMI 2,
COAX IN, OPTI IN, AUX IN 1, AUX IN 2, AUX IN 3,
FM (radio USW), AM (radio MW).
• Or you can switch the source with the direct selection
buttons:
68
“AV Source” – DISC or USB, HDMI 1, HDMI 2
32
“Radio” – FM, AM
31
“Audio Source” – COAX IN, OPTI IN, AUX IN 1,
AUX IN 2, AUX IN 3
The selected source is shown in the display panel
13
.
Adjusting the volume
• Increase the volume: Push the button
5
“Vol +” or the
button
40
“”.
• Decrease the volume: Push the button
5
“Vol –” or the
button
40
“Volume –”.
The selected volume is shown in the display panel
13
in
the range from 0 (low) to 40 (high).
Mute
• Turn off the sound with the button
39
“
”
.
The notice “MUTE ON” will appear in the display
panel
13
.
• Turn the sound back on: Push the button
39
“
”
again
or adjust the volume.
15
32
40
39
31
68
69
11
13
2
5
Basic functions
