• Concept E 450 Digital
15
Setting the volume
Setting the system volume
•
On the device:
Adjust the volume of the entire sys-
tem using the buttons
Vol +/– (9)
.
•
With the remote control:
Adjust the volume by
turning the control dial
(20)
.
The set volume will also appear optically on the vol-
ume display.
Setting the volume of the individual speakers
1. Tap on the sensor field
(14 – 19)
of the correspond-
ing speaker.
The sensor field will illuminate and the current set
volume be displayed.
2. Set the volume for the selected speaker with the
buttons
Vol +/– (9)
or the control dial
(20)
of the
remote control.
3. Follow the same steps, if applicable, with the other
speakers.
Mute
• By briefly pressing on the middle of the control dial
(20)
repeatedly, you can turn the sound on or off.
Setup
In setup mode, you can check the volume of the indi-
vidual speakers and make permanent settings.
4. At the same time, tap on the sensor fields
SR RIGHT (16)
and
SR LEFT (18)
to enable setup
mode.
The sensor field
LEFT (19)
will illuminate; you will
hear noise from the left front speaker; the volume
set for the speaker will be displayed.
5. If applicable, correct the volume using the buttons
Vol +/– (9)
or the control dial
(20)
on the remote
control.
After 5 seconds without any input, the next speak-
ers will be actuated one after another (CENTER
ð
RIGHT
ð
SR RIGHT
ð
SR LEFT
ð
SUB
ð
normal
mode).
By pushing on the middle of the control dial
(20)
,
you can select the previous speaker again (ends at
LEFT).
6. Set the optimal volume for each speaker this way.
After the subwoofer has been set, the
Concept E 450 Digital returns to normal mode. The
settings are saved as a result.
9
20
Volume display
14
19
15
16
18
17
