Teufel Cinebar 50 Special Edition, Technical Specifications And Operating Instructions, Page: 12 / 16

12
·
Cinebar 50
Adjusting the volume · Selecting the sound source
Setting the sound levels on the subwoofer
As the subwoofer has its own sound level control,
this should be in the maximum position. If you use
this position as a starting point, you can make
fine adjustments later using the remote control,
depending on the current sound programme.
This is done as follows:
First set the subwoofer level to position “0” using
the remote control (see above).
Now play a high-quality CD on the Cinebar 50 Sy-
stem. Adjust the volume control on the subwoofer
until you achieve a harmonious sound.
Selecting the sound source
The Cinebar 50 System can choose between five
possible sound sources (inputs).
Ě
Aux 1
Ě
Aux 2
Ě Coaxial
Ě Optical
Ě
USB
The sound source is selected either by repeated-
ly pressing the source button on the Cinebar 50
Unit or on the CB 50 RC remote control. The coaxi-
al, optical and USB inputs have their own buttons.
Aux 1 and Aux 2 share a button. You can switch
between the two inputs by repeatedly pressing
on the Aux 1/2 button.
The display on the Cinebar 50 Unit shows you the
input that has been selected.
Note
The closer you place the subwoo-
fer to a wall or corner, the louder
you can hear the bass playback.
Note
Use the mute button on the CB
50 RC to completely stop sound
playback at any time.
Setting up the subwoofer
Use the Sub +/Sub - buttons to adjust the sub-
woofer volume within the working range of +/-
12dB. The display shows the corresponding value.
Use this button to adjust the subwoofer to the
current sound program.
Adjusting the volume
Press the (+) button to increase the volume. Use
the (-) button to reduce the volume. Alternatively,
you can also use the appropriate operating controls
on the Cinebar 50 Unit (Vol -/+).
Please refer to the information below about setting
the volume on the subwoofer.
Note
We recommend that you buy a
Teufel sound level meter (from
our online shop) to measure the
level precisely. You can determine
the exact output level from both
sound sources using this appli-
ance and the usual test signals.
Sub+
Sub-
Aux 1/2 Optical Coaxial +
–