Synchronising the controller to receiver
Brighter for longer
CONTROLLER AND RECEIVER
www.teucerled.co.uk
2) Turn ON the remote.
1) Confirm that receiver is correctly connected with power supply and LED strip. The strip should light up when
turned on. Turn it off.
All controllers and receivers sold in a pack are pre-sychronised. There is no need to sync the remote to the re-
ceiver. Only follow instructions below if you are adding another receiver with the same remote.
4) Sync the remote controller to the additional receiver by pressing the highest brightness button within 3 sec-
onds of powering the receiver. (Do not press and hold.)
3) Turn ON the second receiver.
5) Repeat the above instructions to synchronise additional receivers.
Press to
turn ON
ON
OFF
Press highest
brightness
bu�on
ON
OFF
LR-W and LRR-W
1 zone RF controller and receiver for single colour LED strip
