Synchronising the controller to receiver
Brighter for longer
CONTROLLER AND RECEIVER
www.teucerled.co.uk
1)
Turn the controller ON. Red LED indicator will be light up.
3)
Ensure the receiver has power. Press the learning key on the receiver.
4)
Ensure the controller is turned ON (red light
indicator ON) and press the zone you which to
allocate to the receiver, than touch the colour
wheel. The LED strips will blink to confirm syn-
chronisation has been successful.
6)
To clear the receiver from a selected zone, simply press and hold the learning key for 5 or
more seconds. The receiver will be reset to the default factory settings.
Learning key
1
2
3
LRR-WTC
Learning Key
4
MASTER SLAVE
W
2)
Set the receiver LRR-WTC as a MASTER OR SLAVE.
Allocating the receiver as a master or slave is important to ensure your LED strip and receiv-
er are fully synchronised. There can be only 1 master receiver per zone.
close circuit for MASTER
open circtuit for SLAVE
1
2
3
LRR-WTC
Learning Key
4
MASTER SLAVE
W
1. Select your zone
2. Touch the colour wheel
The LED strip will flash
to confirm synchronisa�on.
S1
S2
S3
W+
5)
Just repeat the learning process to synchronise several receivers to the same controller.
LR-4RGBW and LRR-WTC
4 zone RF & WIFI controller and receiver for RGBW LED strip
