TESY CH20060IX Instructions For Use And Maintenance Manual Download Page 3

  

Instructions for use and maintenance

       

3

EN

English

 •

Only qualified electrician shall make the electrical 
connections. 

 •

Any installation done by unauthorized personnel 
may result in lower performance, damage to the 
appliance or accidents.   

 •

Do not plug the appliance in the socket before the 
electrical connections have been completed. 

 •

The socket shall be accessible at all times so that the 
plug can be taken out of it immediately if necessary! 

 •

Never pull the power cord or the appliance itself 
while unplugging it from the mains. 

 •

Should you decide to stop using an appliance of 
this kind, it is recommended to render it unusable 
by cutting off its cord after you have disconnected 
it from the mains. It is also recommended to secure 
all appliance-related risks, especially with regards to 
children who may use the appliance to play with it.   

 •

Do not touch the lamps if they have been on for a 
long time – they may burn your hands because they 
are hot. 

 •

Follow the relevant rules and guidelines for ducting 
out the exhaust air.   

 •

You need to provide adequate ventilation in a room 
where the range hood will be used simultaneously 
with an appliance which burns gas or another type 
of fuel (Not valid for appliances which recycle air 
back into the room).  

 •

There is a risk of fire if the cleaning is not done in 
accordance with the instructions.  

 •

Clean the appliance regularly. You must disconnect 
it from the mains prior to cleaning it.

 •

Never touch the appliance with wet or damp hands 
– this is dangerous for your life!

 •

You shall not light any food on fire (flambé) under 
the range hood.

 •

The exhaust air shall not be discharged in a chimney 
which is used for discharging the exhaust gases from 
appliances using gas or other type of fuel (Not valid 
for appliances which recycle air back into the room).  

 •

During installation you should observe the 
minimum distance between the hot plate surface 
on which cookware will be placed. When the range 
hood is placed over domestic appliance which 
uses gas, then the distance shall be at least 65 cm. 
If the instruction manual of the gas hot plate itself 
indicates bigger distance, then it should be taken 
into account. The distance of 65 cm may be reduced 
for the inflammable parts of the range hood and for 
parts which operate under safe ultra-low voltage, 
which, if they get deformed, will not give access to 
parts that are charged with voltage.        

 •

Switch on the range hood only after You have 
placed a frying pan, cooking pot or another 
cookware on the hot plate. Otherwise the heat may 
cause deformities to some parts of the range hood.   

 •

Do not leave cookware with hot oil on the hot plate. 
Cookware containing hot oil may cause self-ignition.

 •

Be careful with curtains and table cloths while 
cooking, e.g. frying, because the oil may set them 
on fire.

 •

Ensure that filters are replaced in time. Filters that 
are not replaced/cleaned pose risk of fire due to the 
greasy deposits on them.  

 •

Do not use materials which are not heat resistant 
instead of filters.  

 •

Do not use the range hood without the aluminium 
filters. Do not remove the filters while the appliance 
is operating.  

 •

In case of fire disconnect the power supply of the 
range hood and of the stove. (Unplug the appliance 
from the power socket or switch off the circuit 
breaker.)

 •

Switch off the appliance during its maintenance. 
(Unplug the appliance from the power socket or 
switch off the circuit breaker.)

 •

If the range hood and another appliance running 
on energy different from electricity operate 
simultaneously, the negative pressure in the room 
shall not exceed 4Pa.

 •

If in the same place where the range hood is located 
there is also an appliance on liquid or gaseous fuel, 
then this appliance shall be placed in an airtight 
container.

 •

If you are discharging the exhaust air through the 
chimney, use pipes with diameter 120 or 150 mm. 
The pipe connection should be as short as possible 
and to have the minimum possible number of 
curves. 

 •

Use a circuit breaker with maximum current of 6 
Ampere at the installation of the range hood for 
your safety.

 •

If the cord is damaged, it has to be replaced by an 
authorized service centre or qualified technician in 
order to avoid any dangerous situations.

 •

In case of fire disconnect the power supply of the 
appliances, extinguish the fire; never use water!

UNPACKING THE APPLIANCE 

 •

Upon unpacking the appliance please verify that it 
has not been damaged during transportation and it 
has been delivered in full! In case of any damage or 
incomplete delivery, please contact your authorized 
seller!

 •

Do not dispose of the original box! It may be used 
for storage and transportation to avoid any possible 
damages resulting from transportation!

 •

Disposing of the packaging material shall be done 
in the suitable manner!

 •

Children shall not play with the polyethylene bags!

Summary of Contents for CH20060IX

















Reviews: